With a few simple craft supplies you might be able to put your beaded bracelet back together easily. https://www.myworldofbeads.com/how-to-get-good-beading-tension Revamp the beads and charms on your Pandora bracelet to adjust how it looks. 8mm gemstone beads, 18 – 27 beads, depending on wrist size (a mala bracelet traditionally uses multiples of 9 beads, plus any spacer beads, so you may want to play with your design before stringing your beads) 8mm spacer beads, 3 – 5 beads, depending on your design (rudraksha beads make a nice addition to a mala bracelet) Silk tassle Knit a loop and tighten your knot – thus the name “Loops & Knots.” Step 4: Repeat – Run through the entire string of beads knitting a loop into every gold sequence of beads between the 2nd and third gold bead. However, what makes it special is the silicone lining inside the bead. Add, remove or rearrange the beads and charms for an entirely new look. And you can embellish the cord ends with beads, charms, small pendants, or whatever you like. The wrist gear specialists of WatchBandit have a great blog called Spotted where you can see photographs of their customers wearing anchor bracelets and other men’s bracelets in different ways. There are 2 factors in choosing bracelet size—wrist size and bead size. When the elastic is pre-stretched, it will snap back to the same size without losing any of its elasticity. Store the bag in a safe place until you are ready to repair the bracelet. Opt for simplicity with just a few gold beads, or make a statement with a variety of gemstone beads. You can tell when this hasn’t been done because the beads may be a little loose or the bracelet stretches a bit the first time you pull on it. Beaded Wrap Bracelet: This Instructable guides you through the steps to create a beaded wrap bracelet. Close your Pandora bracelet once you are satisfied with your adjustment. Trim the tail of the beading cord only. Memory wire acts like a spring to be flexible and fit a broad range of sizes. You may wish to reinforce your beading cord knot with a dab of glue (fabric or super). Tie all three tails (two leather and one beading cord) in an overhand knot and tighten it close to the last bead. To loosen the bracelets, pull gently on the sides of the bracelet by tugging the loose strings through the slip knot. Or to make a less fancy bracelet, just tie the knots on the cord ends and skip the embellishments, like this: Here’s How This Simple Bracelet Works: Slide the bead to tighten the leather loop, so the knotted cord ends won’t pull out of the loop: The bead itself is seamless and resembles a typical, nearly round sterling silver bead or rondell shape. Many people are comfortable with the medium size. Feel free to mix and match anchor bracelets with other bracelets in your collection. There's no need to untie the bracelet to adjust the size as they can be adjusted for 6-12 inch wrists! To tighten any of your adjustable cord bracelets, pull on the string ends on each side of the slip knot. Continue to the next gold bead sequence in the pattern and repeat this step. They look stylish with beaded bracelets and metal bracelets. As soon as the bracelet breaks, make sure you haven’t lost any of its parts. When you place a compatible chain or bangle wire through the stopper bead, the silicone grips it so the bead stays just where you place it. Save all the pieces in a sealed zip-top bag.